[DECtalk] DECTalk command processing in NVDA add-on

[joshknnd1982 at gmail.com]

In addition, make sure you set send to synthesizer, to always, in the combo
box next to the ppunctuation box in the symbols pronunciation dialog.


-----Original Message-----
From: Dectalk <dectalk-bounces at bluegrasspals.com> On Behalf Of Paul balfe
Sent: Saturday, September 17, 2022 17:01
To: Blake Roberts via Dectalk <dectalk at bluegrasspals.com>
Subject: Re: [DECtalk] DECTalk command processing in NVDA add-on

Blake.

It didn't work.

On 9/17/2022 4:43 PM, Blake Roberts via Dectalk wrote:
> Hi everyone,
>
> Two gentlemen wrote to me off-list this afternoon stating they could 
> not get DECTalk commands to process with the new NVDA add-on after 
> doing a say all. I wrote to those list members directly with a 
> possible solution. I am sharing part of that response here with minor 
> edits, in case other list members have similar DECTalk comand 
> processing issue and need a solution. See below for resolution steps.
>
>
> I just remembered that when I was using an old NVDA DECTalk add-on 
> years ago, I had to make some changes in NVDA punctuation/symbols 
> pronunciation. If I set left bracket to "level "none", it reads out 
> the DECTalk code instead of performing the desired action. Try these 
> steps.
>
> 1. Open your NVDA menu and select "Preferences".
> 2. Select "punctuation/symbol pronunciation" and press enter.
> 3. In "symbols" list, find the left bracket.
> 4. Change "level" combo box to most.
> 5. Repeat steps 3 and 4 for the right bracket and colon. Press enter 
> when done.
>
>
> Blake
>
> _______________________________________________
> Dectalk mailing list
> Dectalk at bluegrasspals.com
> https://bluegrasspals.com/mailman/listinfo/dectalk
_______________________________________________
Dectalk mailing list
Dectalk at bluegrasspals.com
https://bluegrasspals.com/mailman/listinfo/dectalk