[Rwp] Help with noise removal

[Matt Turner]

Same here, just need the last step
It's not the seventh one down when you Hit shift+p?
That seems to do something, but it only goes from 0 to 1.

On 5/24/2016 4:32 AM, Chris Belle wrote:
> hey, I've figured out everything except the last step.
> where do you adjust the noise reduction amount?
> The only place I can see to do that is the wet slider in the shift p 
> dialogue.
> Kenny did the vid on reaper site, but of course, you can't see which 
> slider he's adjusting.
> I figured out how to get a noise print, and to do all the rest.
> So any one who's done this how bout the reduction slider?
>
>
> On 5/23/2016 12:19 PM, Nolan Darilek wrote:
>> Hey all. New to Reaper and decided to give it a shot after fighting 
>> with Audacity for years and feeling like it makes my light audio 
>> editing a pain. I've been reading lots, and while there's plenty of 
>> information out there, it seems to be presented across several 
>> different sources and makes getting up and running challenging. So 
>> apologies if there are basic answers to my questions which I just 
>> haven't found.
>>
>> My setup is Reaper 5.20 with the Osara plugin running under NVDA. I 
>> have a track recorded on a somewhat noisy digital recorder, so my 
>> first task is removing noise.
>>
>> I've found this guide:
>>
>> http://www.homebrewaudio.com/reafir-madness-hidden-noise-reduction-tool-in-reaper/ 
>>
>>
>> To make my task easier, I recorded about 30 seconds of ambient noise 
>> on my recorder before my voice begins. I set the loop start/end 
>> points, enabled repeat, ensured that the track contains only noise. 
>> Then I followed these instructions right up to the point where I'm 
>> told to close the effects window, which I can't seem to do. What I do 
>> is enable the Create Noise Profile checkbox and play my noise, but 
>> nothing I do ever gets it removed.
>>
>> Also, this article seems to imply that eventually you'll hear 
>> silence, because the noise filter will remove the noise from the 
>> repeated track. I never hear silence. Instead, I hear my noisy loop 
>> repeated again and again. Additionally, the Osara commands 
>> shift/control-shift-p claim there are no effects on the selected 
>> tracks. This leads me to believe that I'm just editing effect 
>> parameters, and there's some enable/persist step obvious in the UI 
>> but not apparent to accessibility. I think there's a bit in the 
>> performance settings dialog where it shows effect performance, but I 
>> never see the values climb above 0.
>>
>> What am I missing? Trying to be patient but this is enormously 
>> frustrating. I'm a software developer with lots of experience, and 
>> Reaper shouldn't be *this* confusing. :) Audio editing sure, but I 
>> can't even apply an effect.
>>
>> Thanks.
>> _______________________________________________
>> RWP mailing list
>> RWP at bluegrasspals.com
>> http://bluegrasspals.com/mailman/listinfo/rwp
>>
>
> _______________________________________________
> RWP mailing list
> RWP at bluegrasspals.com
> http://bluegrasspals.com/mailman/listinfo/rwp