[Rwp] Help with noise removal

[Chris Belle]

hey, I've figured out everything except the last step.
where do you adjust the noise reduction amount?
The only place I can see to do that is the wet slider in the shift p 
dialogue.
Kenny did the vid on reaper site, but of course, you can't see which 
slider he's adjusting.
I figured out how to get a noise print, and to do all the rest.
So any one who's done this how bout the reduction slider?


On 5/23/2016 12:19 PM, Nolan Darilek wrote:
> Hey all. New to Reaper and decided to give it a shot after fighting 
> with Audacity for years and feeling like it makes my light audio 
> editing a pain. I've been reading lots, and while there's plenty of 
> information out there, it seems to be presented across several 
> different sources and makes getting up and running challenging. So 
> apologies if there are basic answers to my questions which I just 
> haven't found.
>
> My setup is Reaper 5.20 with the Osara plugin running under NVDA. I 
> have a track recorded on a somewhat noisy digital recorder, so my 
> first task is removing noise.
>
> I've found this guide:
>
> http://www.homebrewaudio.com/reafir-madness-hidden-noise-reduction-tool-in-reaper/ 
>
>
> To make my task easier, I recorded about 30 seconds of ambient noise 
> on my recorder before my voice begins. I set the loop start/end 
> points, enabled repeat, ensured that the track contains only noise. 
> Then I followed these instructions right up to the point where I'm 
> told to close the effects window, which I can't seem to do. What I do 
> is enable the Create Noise Profile checkbox and play my noise, but 
> nothing I do ever gets it removed.
>
> Also, this article seems to imply that eventually you'll hear silence, 
> because the noise filter will remove the noise from the repeated 
> track. I never hear silence. Instead, I hear my noisy loop repeated 
> again and again. Additionally, the Osara commands 
> shift/control-shift-p claim there are no effects on the selected 
> tracks. This leads me to believe that I'm just editing effect 
> parameters, and there's some enable/persist step obvious in the UI but 
> not apparent to accessibility. I think there's a bit in the 
> performance settings dialog where it shows effect performance, but I 
> never see the values climb above 0.
>
> What am I missing? Trying to be patient but this is enormously 
> frustrating. I'm a software developer with lots of experience, and 
> Reaper shouldn't be *this* confusing. :) Audio editing sure, but I 
> can't even apply an effect.
>
> Thanks.
> _______________________________________________
> RWP mailing list
> RWP at bluegrasspals.com
> http://bluegrasspals.com/mailman/listinfo/rwp
>