[Rwp] How to copy and paste time based selection?

[Alan]

Thanks, Juan,

Unfortunately, it's not working for me. Perhaps I changed some setings 
by misstake and my Reaper is not working as expected?

That's what I did:
1. Navigate to bar 2 using page up and page down.
2. Set start of time selection by pressing shift + alt + [
3. Navigate to bar 33 by pressing page up and page down.
4. Set here end of time selection by pressing control+alt+].
5. Select all tracks (output is: 7 tracks selected).
6. Control + c, copy (output: 7 tracks copied).
7. ESC key, remove time selection.
8. Again navigate to bar 32 and pressed control+v. (output: 7 tracks 
pasted... and, yea, it generates 7 more tracks).

In fact, if I try the same with only a track, reaper creates a copy of 
the track, not pastes my seleced area of items on the same track...

Any ideas? Or maybe I'd need to restore all setings...

El 15/03/2016 a las 21:58, Juan Pablo Bello escribió:
> I htink reaper's paradigm is a Little different. The following
> commands should be helpful
>
> copy selected area of items
> cut selected area of items
> fit items to time selection, looping if needed (I have it to control plus H )
> fit items to time selection, stretching if needed
>
> the nice thing about the third one especially is that you can mark
> your selection, then use that command and it will copy paste for you,
> and assuming that you have say, a break on beat 2 of bar 34, it will
> stop right there. so it does even the edit autoMagically for you, all
> in a single keystroke.
>
> To do this on all tracks you set your time selection, then select all
> tracks , then perform that command and I think it should work.
>
> also, try: 1. Setting your time selection, 2. selecting all tracks, 3.
> control+c, 4. Pressing escape to clear your time selection (I think
> this is the step you might be missing as reaper does not clear
> selection when you cut copy or paste), 5. navigating to bar 34, 6.
> pasting.
>
> 2016-03-15 14:41 GMT-05:00, Alan <alan.jdv at gmail.com>:
>> Hi, guys,
>> I'm feeling so stupid right now, after more than 30 minutes of testing,
>> I cannot copy, for example, from bar 2 to bar 34 of a track to paste it.
>> I'd like to copy from 2 to 34 of all tracks to duplicate the length of
>> the recording, but I just cannot figure out how to do it.
>> Reaper is copying my seven tracks all the time and pasting new tracks
>> instead.
>>
>> How does it work?
>>
>> Thanks in advance!
>> _______________________________________________
>> RWP mailing list
>> RWP at bluegrasspals.com
>> http://bluegrasspals.com/mailman/listinfo/rwp
>>
>