[Rwp] snapping automation envelopes

[Patrick Perdue]

I would have thought that, with a square shape, the change would have 
happened exactly half way between the two envelope points. Maybe not.

On 3/13/2016 6:11 PM, James Teh wrote:
> As noted earlier though, setting the shape to square should allow you to
> do this with only two points.
>
> On 14/03/2016 8:08 AM, Patrick Perdue wrote:
>> Yep. That's what I ended up doing. Literally just stuck the third
>> envelope point 1 ms after the second.
>>
>> On 3/13/2016 5:31 PM, Snowman wrote:
>>> Three points?  One at the start with 16%r, and two immediately adjacent
>>> points at the switchover position.  the first is 16%r, and the second,
>>> millisecondes later, is 16%l.
>>>
>>> ----- Original Message ----- From: "Patrick Perdue"
>>> <patrick at pdaudio.net>
>>> To: "Reapers Without Peepers" <rwp at bluegrasspals.com>
>>> Sent: Thursday, March 10, 2016 1:03 PM
>>> Subject: [Rwp] snapping automation envelopes
>>>
>>>
>>>> OK...
>>>> So, I'm still trying to figure out the basics of track automation from
>>>> OSARA's point-of-view.
>>>> I have a track that is panned 16% right for 32 minutes. At this point,
>>>> I want it to snap to 16% left. If I create two envelope points, the
>>>> track, somewhat expected, gradually slides from 16% right to 16% left
>>>> over 32 minutes, which is, of course, what I don't want to happen.
>>>> What is the best way to handle this sort of situation?
>>>> _______________________________________________
>>>> RWP mailing list
>>>> RWP at bluegrasspals.com
>>>> http://bluegrasspals.com/mailman/listinfo/rwp
>>>>
>>>
>>>
>>> _______________________________________________
>>> RWP mailing list
>>> RWP at bluegrasspals.com
>>> http://bluegrasspals.com/mailman/listinfo/rwp
>>
>> _______________________________________________
>> RWP mailing list
>> RWP at bluegrasspals.com
>> http://bluegrasspals.com/mailman/listinfo/rwp
>