[Rwp] snapping automation envelopes

[James Teh]

As noted earlier though, setting the shape to square should allow you to 
do this with only two points.

On 14/03/2016 8:08 AM, Patrick Perdue wrote:
> Yep. That's what I ended up doing. Literally just stuck the third 
> envelope point 1 ms after the second.
>
> On 3/13/2016 5:31 PM, Snowman wrote:
>> Three points?  One at the start with 16%r, and two immediately adjacent
>> points at the switchover position.  the first is 16%r, and the second,
>> millisecondes later, is 16%l.
>>
>> ----- Original Message ----- From: "Patrick Perdue" 
>> <patrick at pdaudio.net>
>> To: "Reapers Without Peepers" <rwp at bluegrasspals.com>
>> Sent: Thursday, March 10, 2016 1:03 PM
>> Subject: [Rwp] snapping automation envelopes
>>
>>
>>> OK...
>>> So, I'm still trying to figure out the basics of track automation from
>>> OSARA's point-of-view.
>>> I have a track that is panned 16% right for 32 minutes. At this point,
>>> I want it to snap to 16% left. If I create two envelope points, the
>>> track, somewhat expected, gradually slides from 16% right to 16% left
>>> over 32 minutes, which is, of course, what I don't want to happen.
>>> What is the best way to handle this sort of situation?
>>> _______________________________________________
>>> RWP mailing list
>>> RWP at bluegrasspals.com
>>> http://bluegrasspals.com/mailman/listinfo/rwp
>>>
>>
>>
>> _______________________________________________
>> RWP mailing list
>> RWP at bluegrasspals.com
>> http://bluegrasspals.com/mailman/listinfo/rwp
>
> _______________________________________________
> RWP mailing list
> RWP at bluegrasspals.com
> http://bluegrasspals.com/mailman/listinfo/rwp

-- 
James Teh
Executive Director, NV Access Limited
Ph +61 7 3149 3306
www.nvaccess.org
Facebook: http://www.facebook.com/NVAccess
Twitter: @NVAccess
SIP: jamie at nvaccess.org