[Rwp] Control Surfaces: I'm about ready to pull my hair out!

[Christopher-Mark Gilland]

Aa!  O, Kayyy?  Let me give that a try.  Thanks for the response.  I'll 
report back.  I'm in the studio now, as a matter of fact, so just give me a 
sec to  load up Reaper and give this a shot.

BTW, I use JAWS 15 on this system.  I have NVDA, but don't prefer it.

Chris.

----- Original Message ----- 
From: "Scott Chesworth" <scottchesworth at gmail.com>
To: "Reapers Without Peepers" <rwp at bluegrasspals.com>
Sent: Tuesday, February 16, 2016 5:22 PM
Subject: Re: [Rwp] Control Surfaces: I'm about ready to pull my hair out!


> Hey Chris,
>
> There's a step in setting up control surfaces when using Reaper in
> Windows that's not intuitive. I haven't read Oreo's instructions on
> the Reaper Access site, but seeing as he's on Mac, he might not have
> known that there's an extra bit of jiggery-pokery Windows users have
> to perform.
>
> In Preferences, navigate down the tree until you get to Control
> Surfaces (it's second from last at the time of writing). If you were
> adding a surface for the first time, you'd want to tab until you reach
> the Add button. Seeing as you've already started setting yours up, you
> could choose it from the first combo box and hit tab until you reach
> the edit button. In this new window, you'll need to select your
> surface protocol (which I'm betting you've already done). Then, here's
> the part that's a bit tricky. Before you hit the ok button, you'll
> need to use your screen readers virtual cursor, because there are two
> important bits of configuration that need to be taken care of that
> don't appear in the tab order. How these are presented changes
> depending on which screen reader you're using, but if you poke around
> in that window you'll find two controls which allow you to choose the
> input and output ports of the surface you're adding. Seeing as we're
> using virtual cursor, you'll need to choose your ports using whatever
> the command to simulate a left click is with your screen reader. Once
> you set both of those ports, hit ok, and you'll be back in the
> Preferences window. One more ok out of that, and you should be good to
> go.
>
> Remember that if you get an error about Reaper not being able to
> communicate with the surface or similar, the first thing to check in
> your case will be that you've gone back into Preferences and disabled
> the surface under MIDI Devices.
>
> Hth, let us know how you get on.
>
> Scott
>
> On 2/16/16, Christopher-Mark Gilland <clgilland07 at gmail.com> wrote:
>> Actually, neither is working, even when both done together, I'm not 
>> getting
>> any error, or anything.  It just flat out won't work.
>>
>> Chris.
>>
> _______________________________________________
> RWP mailing list
> RWP at bluegrasspals.com
> http://bluegrasspals.com/mailman/listinfo/rwp