[Rwp] Introduction and a question about setting up FW 1884with Reaper

[Rod alcidonis, Esquire]

David:

I have achieved partial success by resetting the midi and hardware controls 
to factory default. I now have the transport buttons working, but with a 
very uncomfortable latency. I have to press the play button once or twice to 
get it to do what it does. also, the rewind button goes to the beginning of 
the project and the fast forward to the end as oppose to the previous and 
next bars. I know it's a latency issue and not physical damage to the 
buttons because pressing rewind and fast forward in quick succession leaves 
JAWS hanging for a few second or so. I have increased the buffer in the 
project settings to 512, to no avail. For some reason, when that happens and 
I press the Clock key (next to the Mod Mix), it works as fine for a few 
seconds...

Any tips?


Rod Alcidonis, Esq.

-----Original Message----- 
From: David Regan
Sent: Wednesday, April 13, 2016 3:00 PM
To: 'Reapers Without Peepers'
Subject: Re: [Rwp] Introduction and a question about setting up FW 1884with 
Reaper

Hello Rod

I am no expert but I have managed to make the transition from sonar to
reaper and have my fw1884 operate as a control surface.

I've only had to set it up once so I have gone through the reaper
preferences to remind myself how I did it.

Firstly, you have to disable the fw1884 control ports for input and output
under midi devices.

Then go to control surfaces and add a control surface.  I had to set the
control surface mode to Mackie control and set the midi input and output for
the control surface to fw1884 control.  From memory, if you're using jaws
you will have to use the jaws cursor to find the inputs and outputs and
route pc to jaws to access them.

Finally in the fw1884 control panel, change the control protocol to Mackie
control emulation.

I hope that gets you started.  Don't forget to change the control protocol
back to fw1884 native if you want to use it in sonar.

Cheers.

-----Original Message-----
From: RWP [mailto:rwp-bounces at bluegrasspals.com] On Behalf Of Rod alcidonis,
Esquire
Sent: Thursday, 14 April 2016 2:09 AM
To: Reapers Without Peepers
Subject: [Rwp] Introduction and a question about setting up FW 1884 with
Reaper

Hello gang:

I am Rod Alcidonis. I recently joined the listserv as I am looking to make
the transition from Sonar to Reaper. I am an attorney by profession -- I
only record as a professional hobby. I have been reading the archive and I
have already learned a great deal from you guys.

For the past six years, I have been using an FW 1884 successfully as my
control surface in sonar. I have attempted to get the same setup to work in
Reaper, to no avail. I have been a able to get the midi and audio routing to

work fine, but the control surface functionality appears to be completely
broken. Anyone has successfully configured this board in Reaper?

If you are out there I would appreciate your help. Thanks thanks.




Rod Alcidonis, Esq.

_______________________________________________
RWP mailing list
RWP at bluegrasspals.com
http://bluegrasspals.com/mailman/listinfo/rwp

_______________________________________________
RWP mailing list
RWP at bluegrasspals.com
http://bluegrasspals.com/mailman/listinfo/rwp