[Rwp] getting time

[Chris Belle]

Now this is interestsing when I switch from hours minutes secs and 
frames to minutes and seconds, when I hit home and end I get a time 
reading for one, but bars and beats for the other.

And I guess that's because you said the hours and minutes and secs and 
frames one wasn't supported.

That might be a good one to straighten out, because I think that might 
cause some confusion,
it should logically follow what ever you set in the view options.

After thinking about it, if others agree, I think this should follow 
that setting.


On 11/2/2015 1:57 AM, Chris Belle via RWP wrote:
> Ok, that was the problem, I had the hours minutes secs and frames one.
>
> If enough people would like that, would be handy to have that 
> supported by osara.
>
> Otherwise, am happy for you to work on the top level requests folks 
> are needing.
>
> On 11/1/2015 9:51 PM, James Teh via RWP wrote:
>> On 2/11/2015 1:16 PM, Chris Belle via RWP wrote:
>>> I set my view options to one of the time based ones
>> Which one specifically? Currently, the only time one that OSARA 
>> supports is min/sec, but I could extend this if needed.
>>
>>> But when I hit a cursor movement during recording, I get bar/measure 
>>> based feedback.
>> Which cursor movement? If you're moving by bar/beat, OSARA reports 
>> bar/beat because you're choosing to specifically move by bar/beat. 
>> However, if you press home, end, left arrow, right arrow, etc., you 
>> should get time based.
>>
>> Jamie
>>
>
> _______________________________________________
> RWP mailing list
> RWP at bluegrasspals.com
> http://bluegrasspals.com/mailman/listinfo/rwp
>