[Rwp] getting time

[James Teh]

On 2/11/2015 1:16 PM, Chris Belle via RWP wrote:
> I set my view options to one of the time based ones
Which one specifically? Currently, the only time one that OSARA supports 
is min/sec, but I could extend this if needed.

> But when I hit a cursor movement during recording, I get bar/measure 
> based feedback.
Which cursor movement? If you're moving by bar/beat, OSARA reports 
bar/beat because you're choosing to specifically move by bar/beat. 
However, if you press home, end, left arrow, right arrow, etc., you 
should get time based.

Jamie

-- 
James Teh
Executive Director, NV Access Limited
Ph +61 7 3149 3306
www.nvaccess.org
Facebook: http://www.facebook.com/NVAccess
Twitter: @NVAccess
SIP: jamie at nvaccess.org