[Rwp] Effects Routing

[theoreomonster at reaperaccess.com]

put the pitch shifter in one of the audio tracks fx slots instead of on a bus. If you want only the wet signal when you put the pitch shifter on a bus you will need to uncheck the send to master on the audio track and not the pitch shifter track. 
But if you want the wet dry slider to work as intended you will need to put the pitch shifter on the audio tracks fx as stated above and not  on a bus. 

> On Dec 21, 2015, at 10:56 PM, Snowman <snowman at snowmanradio.com> wrote:
> 
> Guys,  I need  somebody to splane something to me.
> I don't quite understand how Reaper's routing is working.
> I have an audio channel, with a pit shift effect on it.
> When I play it, I hear both the wet and the dry signal, even though the dry slider is set to minus infinity in the shift+p dialog.
> If I go into the i/o dialog, with the i key, and uncheck the master/parent send checkbox, then I hear only the dry signal, not the wet.
> I wondered if this track is also going directly to  the sound card output, without the master, but so far can't figure out how to determine that.
> Any ideas welcome.  Thanks.
>  
>  
> _______________________________________________
> RWP mailing list
> RWP at bluegrasspals.com <mailto:RWP at bluegrasspals.com>
> http://bluegrasspals.com/mailman/listinfo/rwp <http://bluegrasspals.com/mailman/listinfo/rwp>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://bluegrasspals.com/pipermail/rwp/attachments/20151224/1be6feed/attachment-0001.html>