[RWP] Sidechaining in Reaper 4x

[Patrick Perdue]

In this case, midi is completely irrelevant. However, ReaGate does have 
a function that allows you to key the gate on midi event, but again, not 
relevant in this situation.

On 10/12/2013 6:06 PM, Indigo wrote:
> I'm just guessing, without having looked yet for the video on it, or a
> project template, but what if you didn't route the inputs from the IO
> dialog, but tabbed to the dual pair of inputs in the FX chaining page,
> and tried to configure what tracks you fed them with from there?
> I'll bet you can configure the channel of the track that feeds the
> ReaComp inputs, so midi channel would differentiate the stereo pairs of
> inputs from each other.
> Just set your kick drum track on 1 midi channel and the track you want
> to have ducking on another.
> Just guessing,
> Indi
>
>
> On 10/12/2013 5:34 PM, Scott Chesworth wrote:
>> I must be missing something obvious. Seems like if I set this up with
>> sends, both signals will go into the same input of the compressor.
>> Granted, that'll sound different than if I hadn't done it, but that's
>> not the same as sending that secondary signal into the key input of
>> the compressor or whatever they call it in plugins nowadays so that
>> the compressor is reacting to it as a separate source is it? Been a
>> while since I actually patched in hardware, so forgive the potentially
>> rookie question.
>>
>> Cheers
>>
>> Scott
>>
>> On 10/12/13, Drew <amockery at gmail.com> wrote:
>>> You have to press i to view the track IO. Tab to the "sends: add new"
>>> combo
>>>
>>> box and press the down arrow. From there it's pretty much the same as in
>>> reaper 3. The only part I can't figure out is how to change where
>>> that send
>>>
>>> goes; it defaults to the top track or the second track if I'm already
>>> on the
>>>
>>> top track.
>>> ----- Original Message -----
>>> From: "Scott Chesworth" <scottchesworth at gmail.com>
>>> To: "Reapers Without Peepers" <rwp at reaaccess.com>
>>> Sent: Saturday, October 12, 2013 11:05 AM
>>> Subject: [RWP] Sidechaining in Reaper 4x
>>>
>>>
>>>> Does anyone have a workflow for getting this done in Reaper 4 with
>>>> NVDA? Struggling to get some weird arty atmospheric loops to sit in
>>>> the mix here, and I'm thinking some ducking triggered by the drum bus
>>>> might tie things together a bit better.
>>>>
>>>> Any tips appreciated...
>>>>
>>>> Scott
>>>>
>>>> _______________________________________________
>>>> RWP mailing list
>>>> RWP at reaaccess.com
>>>> http://reaaccess.com/mailman/listinfo/rwp_reaaccess.com
>>>>
>>>
>>>
>>> _______________________________________________
>>> RWP mailing list
>>> RWP at reaaccess.com
>>> http://reaaccess.com/mailman/listinfo/rwp_reaaccess.com
>>>
>>
>> _______________________________________________
>> RWP mailing list
>> RWP at reaaccess.com
>> http://reaaccess.com/mailman/listinfo/rwp_reaaccess.com
>>
>
> _______________________________________________
> RWP mailing list
> RWP at reaaccess.com
> http://reaaccess.com/mailman/listinfo/rwp_reaaccess.com