[RWP] Routing Tracks to master track

[Patrick Perdue]

You can't do real track automation without a control surface in Reaper, 
at least not just with ReaAccess, and everything else stock otherwise. 
Maybe some extensions can do it. The promised ReaAccess 2.0, which never 
happened, was supposed to provide such functionality, an automation 
envelope editor, and other such potentially useful tools.

On 5/22/2013 1:12 AM, Chris Belle wrote:
> So is this with just a surface or will this honor your settings on a
> track, from the computer keyboard,  keys and can you actually do snapshots?
>
> In other words, stop the transport, make a setting that will be
> remembered later, and then go on?
>
> Have you actually done this raising and lowering volume and pan and
> other parameters with automation not using a control surface in this
> manner?
>
>
>
> ----- Original Message ----- From: "Indigo" <33indigo at charter.net>
> To: "Reapers Without Peepers" <rwp at reaaccess.com>
> Sent: Tuesday, May 21, 2013 6:55 PM
> Subject: Re: [RWP] Routing Tracks to master track
>
>
>> In Reaper, action 65 is Set All Tracks Automation Mode to Write, and
>> Set all tracks Automation Mode to read is a little below that.
>> Besides write you also have touch, latch and trim.
>> Instead of set all tracks automation mode, while a track is selected
>> with up and down arrows, tab to automation mode and select with arrows
>> on a per track basis.
>> Press enter to keep selection.
>> Indi
>>
>> On 5/21/2013 6:16 PM, Alexander Westphal wrote:
>>> Hi Patrick!
>>>
>>> Well, Sonar is more comfortable in these things. There you can say
>>> "Write Automation" and it will do it. Okay, this is a very simple
>>> explanation, but it is as simple as can be. You go to the track or bus,
>>> go to the item you want to automate, e.g. volume or pan, press
>>> contextmenu, look for "Automation Write" and press enter, press CTRL+R
>>> for Automation Record and change the value while playing with plus and
>>> minus or - if assigned - move the slider on your controller.
>>>
>>> With the Master Bus it is also very simple, because it is available in a
>>> "Bus Panel". In most cases all audio and softsynth tracks are routed to
>>> this. Hope I understood your message right and you needed this
>>> explanation.*grin*
>>
>> _______________________________________________
>> RWP mailing list
>> RWP at reaaccess.com
>> http://reaaccess.com/mailman/listinfo/rwp_reaaccess.com
>
>
> _______________________________________________
> RWP mailing list
> RWP at reaaccess.com
> http://reaaccess.com/mailman/listinfo/rwp_reaaccess.com