[RWP] Routing Tracks to master track

[Patrick Perdue]

Just so you know, that won't do a thing for writing track automation 
from the keyboard, I.E. without a control surface.

On 5/21/2013 7:55 PM, Indigo wrote:
> In Reaper, action 65 is Set All Tracks Automation Mode to Write, and Set
> all tracks Automation Mode to read is a little below that.
> Besides write you also have touch, latch and trim.
> Instead of set all tracks automation mode, while a track is selected
> with up and down arrows, tab to automation mode and select with arrows
> on a per track basis.
> Press enter to keep selection.
> Indi
>
> On 5/21/2013 6:16 PM, Alexander Westphal wrote:
>> Hi Patrick!
>>
>> Well, Sonar is more comfortable in these things. There you can say
>> "Write Automation" and it will do it. Okay, this is a very simple
>> explanation, but it is as simple as can be. You go to the track or bus,
>> go to the item you want to automate, e.g. volume or pan, press
>> contextmenu, look for "Automation Write" and press enter, press CTRL+R
>> for Automation Record and change the value while playing with plus and
>> minus or - if assigned - move the slider on your controller.
>>
>> With the Master Bus it is also very simple, because it is available in a
>> "Bus Panel". In most cases all audio and softsynth tracks are routed to
>> this. Hope I understood your message right and you needed this
>> explanation.*grin*
>
> _______________________________________________
> RWP mailing list
> RWP at reaaccess.com
> http://reaaccess.com/mailman/listinfo/rwp_reaaccess.com