[RWP] ReaAccess instalation error, "some components are missing"

[Indigo]

I haven't tried running both 32 bit and 64 bit Reaper in Windows 7 64, 
but the usual cause for the Some Components are Missing message is that 
you need to open and then close Reaper once before installing ReaAccess.
Sorry if you already did this.
Indigo L

On 11/21/2012 5:46 PM, Jayce Tate wrote:
> Hey,
>
> Jayce here from the UK. I'm a relative newb to the ways of Reaper and
> even more of a newb to mailing lists, so please forgive any social
> blunders! :)
>
> I'm running Windows 7 64, and until now have been running Reaper x64.
> There are a few plugs I need to use for a current project that don't
> have 64-bit distributions, and I couldn't get anything useful out of
> them in terms of accessibility running them bridged in x64. I
> installed the 32-bit version of Reaper, as I read they'll coexist
> happily, but couldn't seem to get ReaAccess to work in that second
> copy of Reaper on the same system. The obvious solution seemed to be
> to uninstall Reaper x64, have 32-bit Reaper as the only DAW installed
> and see if I have any more luck without bridging. Here's where it gets
> interesting. After uninstalling both versions, cleaning up files and
> reg keys that were left behind, the ReaAccess installer now won't get
> any further than "some components are missing", no matter which
> version of Reaper I install. I've tried running Reaper as the
> installer suggests (both versions), and used CCleaner and some manual
> detective work to remove any obvious traces of previous installs. No
> luck so far..
>
> Can anybody suggest what to try next? Sucks to be locked out of Reaper
> mid way through a project :(
>
> Thanks much,
>
> Jayce
>
> _______________________________________________
> RWP mailing list
> RWP at reaaccess.com
> http://reaaccess.com/mailman/listinfo/rwp_reaaccess.com