[RWP] How To Enable Midi Devices With NVDA

[indigo]

1. First, when installing Reaper, open and close Reaper at least  once 
after installation, then install ReaAccess.
Make sure NVDA is check as a screenreader.
2. In Reaper, press ctrl+P to go to options/preferences.
3. Arrow to PlugIns VST.
4. Tab down to midi devices, and continue tabbing down past  the line 
that reads Make Available as Input... and Make Available as Output
A couple of more tabs down, just below Use Joystick... is  the combo box 
for enabling midi devices.
To hear the names of your midi devices, arrow up/down in that box.
The names of your midi devices will have the word Disabled after their name.
To Enable a midi Device:
1. Arrow to  the line with the midi device name.
2 Press Move to Focus; which is NVDA Key and numPad dash.
3. Press NVDA key and num pad enter; to perform the default action, and 
Enabled will appear after the midi device name.
Now the configuration dialog for that single midi device is already 
open; and waiting for you to place checkmarks; one checkmardk to send 
midi messages, and another checkmark if you want the midi device to also 
send midi controller messages.
When finished configuring this  this midi device, repeat the steps above 
for each midi device you want to use; being sure that enabled is shown 
after its name, and that device  is configured for midi messages and 
also control messages, if you want.
When all your midi devices are enabled;
click on okay.